SilverStone Grandia GD09 & GD10 HTPC Cases

Cases|Damping
Viewing page 3 of 7 pages. Previous 1 2 3 4 5 6 7 Next

INTERIOR

The GD10 has a typical layout for an HTPC style enclosure. A removable 5.25/3.5/2.5 inch drive bay hangs over the front/right side of the case, over a portion of the motherboard. The side fans blow air in, directing all the exhaust through the vent on the top cover and out the back via 80 mm fan mounts and ventilated expansion slots.


The drive cage can hold a full sized 5.25 inch optical drive or two 2.5 inch drives, while a single 3.5/2.5 inch drive can attached to the underside. An additional 2.5 inch drive can be secured to the case floor in the corner near the front control panel and all the cables.


Damping strips line the sides of the 3.5 inch position to help reduce vibration.


Another 3.5 inch drive can be installed on its side in front of the cage.


To limit the noise output, SilverStone has equipped the GD09/GD10 with 3-pin fans that spin at just 900 RPM at full speed.


Rather than one long filter, the left side is serviced by smaller single fan variants for the intake fan and power supply fan.



Previous 1 2 3 4 5 6 7 Next

Cases|Damping - Article Index
Help support this site, buy from one of our affiliate retailers!
Search: