OCZ Power Stream 470

Viewing page 3 of 5 pages. Previous 1 2 3 4 5 Next


The interior is packed, and large black anodized heatsinks are used.

The plastic sheeting on the cover extends down the side to block small vents.

Large 1000 uF capacitors nestled beneath heatsink.

Many of the coils are wrapped in heatshrink.

The red arrow points to the fan control circuit, screwed to HS..

Here's the fan control PCB. Note space for third fan output: Probably adapted from a 3-fan PSU.

The TOP label on the transformer rings a bell, but can't place it...

The output cables are very long.

  • 20" cable for main 24-pin ATX connector
  • 2 x 20" cable for heavy wrapped cable (flexible) with single 4-pin black connector marked VGA/HDD. These look as if they are off a separate line, but they are not. They are wired in parallel to the standard 12V and 5V lines.
  • 18" cable w/AUX connector cable
  • 26" cable w/dual-12V and quad-12V connectors
  • 26" cable w/two SATA power connectors
  • 2 x 36"cable w/three 4-pin connectors and one floppy drive connector

Previous 1 2 3 4 5 Next

Power - Article Index
Help support this site, buy from one of our affiliate retailers!