Viewing page 3 of 6 pages.
Previous 1 2 3 4 5 6 Next
MORE PSU DUCT DETAILS
Once in place, two holes were poked on each side...
...so that ordinary plastic wire straps (zap straps) could be used to secure the duct.
The duct had to be cut open a bit on this side for the PSU output cables.
Inside the duct: There was a small gap on the right, which I closed with a bit of sticky-backed foam.
Here's how the finished duct looks from below.
| Help support this site, buy from one of our affiliate retailers! |
|
