Enermax Noisetaker II (Rev. 2.2): A New Rev of an Old Fave

Viewing page 3 of 6 pages. Previous 1 2 3 4 5 6 Next


The internal circuit design has changed very little, if at all. The basic layout is the same as the previous version, and there are no obvious changes in components. The layout is also very similar to Enermax' modular series, the Liberty.

The same gold heatsinks we've seen in other Enermax power supplies.

Densely packed components do not allow a lot of room for airflow.

The heatsinks themselves are on the small side for such a high capacity power supply, but the twin fans and back vent should have no problem moving air across them. The fin arrangement provides plenty of surface area.

Gold heatsinks... and little copper fingers for a particularly hot component.

Active power factor correction.

Previous 1 2 3 4 5 6 Next

Power - Article Index
Help support this site, buy the Enermax NoiseTaker II (Rev. 2.2) EG701AX VE(W) SFMA 600W Power Supply from one of our affiliate retailers!