Review: Seagate Barracuda 7200.7 HDD by Dru

Storage
Viewing page 2 of 2 pages. Previous 1 2

System Setup

To test these drives for noise, I needed to put them into a near silent system which is described below:

  • Antec Performance II Series SX835II case
  • Nexus NX-3000
  • Asus A7N8X
  • Athlon XP 2100+ Thoroughbred
  • Thermalright SLK-800 with Panaflo 80mm L1A @ 7V
  • Corsair 256MB DDR333 PC2700 Cas 2
  • Ati Radeon 9500 Pro with Zalman ZM80A-HP
  • 2 Panaflo 80mm L1As @ 5V at rear of case (exhaust)
  • NoiseMagic NoVibes III (used for 2nd half of testing)

To make sure the system was quiet, I booted the system up without connecting a hard drive. The system was pretty silent. Remember from the beginning of the review that I mentioned I don't have any sound measuring equipment except for my ears. ;)

Drive Acoustics

I used Hitachi's Feature Tool (v1.70) to check the settings of AAM for both drives. By default, the Barracuda IV was set to "Quiet Seek Mode." Strangely, Feature Tool reported the Barracuda 7200.7 as not having the AAM feature. Why does Seagate list both Quiet and Performance seek info on their Barracuda 7200.7 data sheet? Last I checked, Seagate's own utilities didn't provide a way to change the AAM for their drives (my ignorance?). If AAM is able to be toggled for the Cuda 7200.7, I wasn't able to do it. My guess is it's set to Performance.

Direct Mounting Setup

Now it's time to compare the hard drives. I tested them in two ways. First, I tested the hard drives by mounting them as shown in the picture below. You can see that I installed the hard drive in the center of the lower 3 1/2" cage.

With the Barracuda IV and the case open, I notice a faint whine while running idle. I put my ear about 6 inches away from the drive. During access, I can hear the seek noise but am pleased with it's very quiet seeks. With the case closed, I cannot hear the idle whining at all. The seek noise is still audible but only when there's absolutely no other noise in the room. In other words, it's very quiet but not inaudible.

I now swap in the Barracuda 7200.7. Upon system power up, I already notice it to have a slightly higher pitched whine to it. With the case open, it's very noticable (again, at 6 inches away). Seeks are also a "tad" higher in volume but with the same pitch as the Cuda IV. At this point, I'm worried that I'll be able to hear the drive's idle whine even when the case is closed. Fortunately, when the case is closed, the idle whine is almost inaudible (if I concentrate enough on the whine, I'll notice it). However, the seeks are noticably more audible even with the case closed yet somewhat tolerable. If you need absolute silence, this solution won't work for you.

Suspension Setup

I must say I'm a believer in the NoVibes III since I've been using it mainly with a Cuda IV. The drives were mounted as shown below. I chose to install the drives in the lowest possible 5 1/4" bay (recall that the NoVibes II requires a 5 1/4" drive bay). If you've read elsewhere about the NoVibes III, you know that it helps mostly by reducing seek noise and not idle drive noise.

If anything, the Barracuda IV is a great candidate for the NoVibes III. When the case is closed, you cannot hear this drive at all! There's no whine nor seek noise. It's a must have for the extreme silent enthusiast. Of course, some have DIY jobs that probably work just as well as the NoVibes III.

Now, let's see how the Barracuda 7200.7 performs. Again, with the case closed, I really can't make out the idle whine. I must say that there is faint audible seek noise with suspension but it's quite tolerable. The seek noise is reduced to at least half of the direct mounting way. To me, it sounds almost as quiet as the Cuda IV with direct mounting. For me, the Cuda 7200.7 while suspended is a good and worthwhile solution over direct mounting.

Heat

With subjectiveness, I tested the heat of the drives by putting my hand on top of the drives after being powered on for at least 1 hour (closed case). The Barracuda IV seems to get pretty warm compared to the Cuda 7200.7. I'd have to say the most impressive part of reviewing the Cuda 7200.7 was how cool it ran. I'd have to say the difference in temperature between the Cuda IV and 7200.7 is significant. Seagate was able to engineer the Cuda 7200.7 to have better performance than the Cuda IVs yet run much cooler. I can leave my hand on top of the Cuda 7200.7 without any discomforts. The Cuda 7200.7 runs just slightly warm.

After doing the subjective heat test above, I utilized DaleSoft's DTemp the next day. I came up with the following:

DTemp Barracuda IV 40GB Barracuda 7200.7 80GB
Direct Mount 31C 31C
Suspended 43C 43C

So now, my subjective heat test looks false. After some thought, I have concluded that maybe the temp. sensor is in a different location for each of the drives. Perplexed, I felt the drives again and still feel that the Cuda 7200.7 felt cooler (I put my hand on the label side of the drives which was at the top while mounted). The chassis temp. was 32C in all of the test cases, and the room was 21C. While suspended, the drives did show being 12C higher. However, Seagate claims the maximum operating temperature of the drives to be 60C. Some might feel more comfortable with either direct mounting or running a fan over the HD.

Benchmarks

Does the Cuda 7200.7 perform better than the Barracuda IV and V series of drives? I used the same system setup from the previous page. I used Futuremark's PCMark2002 for testing. Results are below.

PCMark2002
Barracuda IV 40GB
Barracuda 7200.7 80GB
CPU Score
5241
5233
Memory Score
4002
4009
HDD Score
910
1115
- Cached File Write
25.9 MB/s
29.6 MB/s
- Uncached File Write
27.6 MB/s
48.4 MB/s
- Cached File Read
37.3 MB/s
40.5 MB/s
- Uncached File Read
39.1 MB/s
51.3 MB/s
- File Copy
8.6 MB/s
9.8 MB/s

The Barracuda 7200.7 is faster in every respect!

I next compared the drives using SiSoftware Sandra 2003 Standard. Results are below.

Sandra 2003
File System Benchmark
Barracuda IV 40GB Barracuda 7200.7 80GB
- Drive Index 25,160 KB/s 33,650 KB/s
- Buffered Read 51 MB/s 59 MB/s
- Sequential Read 37 MB/s 49 MB/s
- Random Read 6 MB/s 8 MB/s
- Buffered Write 54 MB/s 57 MB/s
- Sequential Write 37 MB/s 50 MB/s
- Random Write 8 MB/s 8 MB/s
- Avg. Access Time 8 ms 7 ms

Conclusion

I must say I'm impressed with the increased performance with the new Barracudo 7200.7 line. I did not make the effort to compare against competitors like the IBM 180GXP series or Maxtor DiamondMax Plus 9, but my guess is Seagate is not wanting to be left behind, performance-wise. The Barracuda 7200.7 drives "subjectively" run cooler than their past generation relatives with better performance. If you want to trust the DTemp results, you are still gaining more performance with the same heat.

Our main focus here is noise. The Barracuda 7200.7 is not a Barracuda IV in the noise category. Even today, I don't think any drive exists that can beat the Barracuda IV's very low idle whine and seek noise. However, with the nice increase in performance for the Cuda 7200.7, the idle and seek noise is only so slightly higher than the Cuda IV's noise levels. With a closed case, the most noticable difference is the seek noise being slightly higher.

At least two questions remain:

1) Why did Seagate not incorporate the SeaShield for the Barracuda 7200.7 series?

2) Can the SeaShield from either a Barracuda IV or V drive be installed onto a Barracuda 7200.7 "and" further reduce noise?

If you are seeking absolute silence, I still recommend the Barracuda IV. They are still available today. If you want an increase in performance and don't mind spending the extra money in suspending your drive (or DIY for cheap), then I say get the Barracuda 7200.7. As for me, I'm leaving my Cuda 7200.7 suspended in my main system.

* * * * *

Discuss this article in our Forums.

Previous 1 2

Storage - Article Index
Help support this site, buy from one of our affiliate retailers!
Search: