Search found 3142 matches
- Tue Dec 15, 2009 11:49 am
- Forum: Off Topic
- Topic: Compulsory Voting
- Replies: 43
- Views: 18682
Compulsory voting would take away another freedom America was built on and after that European nations followed after fall of Monarch's. Every person has right to vote or not to vote. If people don't vote, maybe politicans should think how they could make people vote... other than forcing people do ...
- Tue Dec 15, 2009 11:45 am
- Forum: Off Topic
- Topic: If you could ask God one question ...
- Replies: 357
- Views: 573909
Wether God exists or not, is not our choice. All we can do is choose wether we believe God or not. God will believe in us. And do sound more smart than I actually am, I'll post few quote's I like from men who could think out of the box and challenge mainstream believes of "truths" "The irrationality...
- Thu Dec 10, 2009 1:23 pm
- Forum: System Advice / Troubleshooting
- Topic: virtual playground
- Replies: 8
- Views: 3790
I'd probably go for Intel way, now that Intel is supporting with its virtualization in its every CPU and Intel has some advantage in raw performance over AMD. You're going quad core, which is very wise choice when it comes to virtualization. 4 GB memory is fare minimum for good virtualization, 6 wou...
- Thu Dec 10, 2009 1:13 pm
- Forum: Fans and Control
- Topic: Which is the quietest 120mm PWM fan?
- Replies: 90
- Views: 53674
Five fans? Five 1450 rpm fans? Hard drive louder? What is going on in this place? Yes, five Scythe gentle Typhoon 1.450rpm and (+) one 220cm. For the air intake, that is. :D :D The case is very big, you know. :P :P You don't get silence huh? No way in hell 1,450rpm fan is quiet. My 1,200 rpm slipst...
- Wed Dec 09, 2009 5:30 am
- Forum: Cases and Damping
- Topic: best potential silent case
- Replies: 3
- Views: 2120
If you have less than 4 HDD's in your system, Solo is tough to beat. Its smaller than P18x and has suspension for HDD's. Solo's down side is that it cannot fit full elngth VA cards like 5970, 4870x2 and so forth. I have both, Solo and P182. I modded both. But I say this: P182's door helps a lot when...
- Wed Dec 09, 2009 12:11 am
- Forum: Fans and Control
- Topic: Quietest alternative to the P4 Socket 478 CPU stock fan
- Replies: 5
- Views: 4131
Any Scythe Cooler you can fit will have still compability for old P4 socket. Ninja 2, Mugen 2, Kama Angle etc all have list compability for that old socket. And one of the best qualities in Scythe's cooler's is that they have good fans and when you sometimes upgrade your computer, you have great cha...
- Tue Dec 08, 2009 6:04 am
- Forum: CPU Cooling
- Topic: passively cool Celeron 430 in a Shuttle
- Replies: 1
- Views: 1265
- Tue Dec 08, 2009 5:54 am
- Forum: Fans and Control
- Topic: Initial Impressions: S-flex 92mm 1000 RPM variant
- Replies: 1
- Views: 2644
Initial Impressions: S-flex 92mm 1000 RPM variant
Hello everyone! I got new fans and I decided to give small impressions of them. Fan model is Scythe SFF92A i.e. Scythe S-flex 92mm 1000 rpm (-/+150 rpm ) variant. For those who do not know, S-flex is Sony Fluid Dynamic Bearing. Compearing to sleeve bearings 30,000 and Ball bearings 50,000 and Dual B...
- Fri Dec 04, 2009 1:18 pm
- Forum: Video Cards & Monitors
- Topic: help finding right video card
- Replies: 2
- Views: 2137
If money is not an object just hire a consultant to do this for you. Cuonsultants are usually a big waiste of money in most cases. If heat is issue in case then it would be good to have card that exhausts air from rear. A Hybrid Crossfire would be also a opinion worth of consideration. or then just...
- Mon Nov 16, 2009 10:10 am
- Forum: System Advice / Troubleshooting
- Topic: Non-gaming micro ATX primary computer
- Replies: 8
- Views: 4354
Seems good and solid build. I hope you get good sample of bigboy fan, they are hard to replace but are good and in minimum are barely noticable and bring no vibrations. The fan comes with Mugen 2 is same that is in Ninja. Slipstream PWM variant. Perhaps best stock fan so far. No reason to change that.
- Sun Nov 15, 2009 2:47 am
- Forum: Power Supplies
- Topic: My NX-5000 R3 Review
- Replies: 1
- Views: 6462
- Fri Nov 13, 2009 1:03 pm
- Forum: General Gallery
- Topic: Machines of the Tortuga (56K Warning update: 21.08.2011)
- Replies: 21
- Views: 29306
A some addition to my Wolflair A minor change: http://i294.photobucket.com/albums/mm103/thejamppa/Computers/th_DSCF1791.jpg Here's improve rubber sealing on top. http://i294.photobucket.com/albums/mm103/thejamppa/Computers/th_DSCF1788.jpg Amberish glow is pretty good looking in dark. A lot less obst...
- Fri Nov 13, 2009 12:35 pm
- Forum: System Advice / Troubleshooting
- Topic: My shopping cart, your expertise
- Replies: 10
- Views: 4954
Hello Again! Almost any cooler these days comes with Core i7 or core i5 support. Xigmatek HDT-S1283 and its clones are very good solutions for Core i's. There isn't much difference in memories. Almost any brand gives life time warranty. Since you don't go overclocking Kingston Value might be good ch...
- Thu Nov 12, 2009 3:29 am
- Forum: Video Cards & Monitors
- Topic: What would you [recommend?]
- Replies: 1
- Views: 1362
What would you [recommend?]
Hi all! What kind of VGA adapter would you recomend for following criteria: mATX case. No extra power plug must be able to run SolidWorks and Catia v.5 programs I was thinking something into line of HD 4650 or HD 4550 series. What else you could recomend? They can have fans. Situation my School will...
- Wed Nov 11, 2009 1:20 pm
- Forum: Off Topic
- Topic: USA's Annual Military Day
- Replies: 15
- Views: 5430
- Wed Nov 11, 2009 1:07 pm
- Forum: System Advice / Troubleshooting
- Topic: PSU recommendation for high-end gaming system
- Replies: 6
- Views: 3631
Terve! If you're not affraid to put effort to your case by dampening it, Antec Three Hundred + Bitumen matt is quite killer combo. Bitumen is not expensive. Antec Three Hundred is decent case even without padding but you need to change top fan. You get good Sharkoon 900 rpm 140mm fans from coolputer...
- Tue Nov 10, 2009 12:45 pm
- Forum: System Advice / Troubleshooting
- Topic: motherboard power question
- Replies: 8
- Views: 3664
You really don't need those 4 extra pins, depending on your CPU. I got Asus P45 board. It has 8-pin connectory for CPU like you do, but 4 pins have been placed under removable cap and since I use only E8400 Dual core I have not bothered to route 8-pin connector there but I have used 4-pin. But you h...
- Tue Nov 10, 2009 9:05 am
- Forum: Newcomers Briefing Room
- Topic: My introduction :)
- Replies: 4
- Views: 3214
- Tue Nov 10, 2009 8:59 am
- Forum: Cases and Damping
- Topic: New Antec case: Lanboy Air
- Replies: 40
- Views: 22909
Two things: 1) Two fans in front, one was set to blow air out, one was set it suck in. Was intresting thing, that just popped out to my sight in pictures. 2) When you got 12 fans in case the HDD suspension really saves your ears by suspending HDD /Sarcasm. Looks wasn't bad, but instead adding fans a...
- Tue Nov 10, 2009 3:45 am
- Forum: Fans and Control
- Topic: The Fan Pile
- Replies: 9
- Views: 5277
My fan pile consists: 2 Noctua P12's ( came with coolers ) 3x Slipstream 800 and 1x Slipstream 1200, AeroCool Turbine 3000, 7x Antec Tricool's and 2 regular non-tricool antec 120mm's, 2x Nexus 120mm RealSilent's and 1x Scythe Kama-Fex.. and then I found out some evil Thermaltake multiled-fan colored...
- Thu Oct 29, 2009 12:49 am
- Forum: Video Cards & Monitors
- Topic: ATI and Linux
- Replies: 13
- Views: 5633
My problem has been that everything worked fine in Ubuntu 64-bit 9.4 till day I changed HD 4670 intoHD 4850. After that I could not make ubuntu work with that computer so I wait till I have change and time to install 9.10 and see if I can my Sapphire HD 4850 work with it. However Ubuntu works in int...
- Thu Oct 29, 2009 12:44 am
- Forum: Video Cards & Monitors
- Topic: Random Thought on this whole Video Card Thing - Vent
- Replies: 48
- Views: 21051
I admit that my soon 2 years old and soon 6 month's old HD 4850's were huge overkill's for my needs. I really did not need to upgrade my HD 3850 256MB to HD 4850 512MB when I did. My most demanding game then and after that was Oblivion. However now I am glad I did. I received Crysis as gift, I gto F...
- Fri Oct 23, 2009 12:47 pm
- Forum: Consumer Advocacy
- Topic: Antec Customer Support - Totally Useless
- Replies: 32
- Views: 69158
This is disturbing really. Antec has had one of the best customer services and that has been why I have now 4 computer's with Antec cases and or PSU's. This summer something really happened in antec. right before summer everything worked fine when my P18x's plastic support broke for now reason. I go...
- Fri Oct 23, 2009 12:34 pm
- Forum: General Gallery
- Topic: Machines of the Tortuga (56K Warning update: 21.08.2011)
- Replies: 21
- Views: 29306
my first graphics adapter ever was voodoo. Those were the days. I do hope personally nVidia gets its stuff together, changes its idiotic policies ( closed PhysX vs. Open Havok, paying ridicioules sums in game designer's like they did with Eidos and Batman Arkha Asylum, they fire few executives that ...
- Fri Oct 23, 2009 12:26 pm
- Forum: Fans and Control
- Topic: PWM question
- Replies: 2
- Views: 1715
- Fri Oct 23, 2009 12:24 pm
- Forum: CPU Cooling
- Topic: cost-effective heatsink / fan for Regor 240/245/250 ??
- Replies: 4
- Views: 2763
- Thu Oct 22, 2009 7:04 am
- Forum: Video Cards & Monitors
- Topic: Random Thought on this whole Video Card Thing - Vent
- Replies: 48
- Views: 21051
I got 3 Ati's running in 3 computer's HD 4850 512MB first Patch. I bought it when it was released. Was best performing card in that price segment. I wanted nVidia 9800 GTX+ (prio name change) but availability sucked atm and none were available. So I bought Ati. I bought it for 180€'s during its re...
- Thu Oct 15, 2009 9:48 am
- Forum: Fans and Control
- Topic: 140mm fan for Antec 300 - need advice!
- Replies: 5
- Views: 4213
- Sun Oct 11, 2009 1:35 am
- Forum: System Advice / Troubleshooting
- Topic: Help Getting Started
- Replies: 8
- Views: 3412
- Sun Sep 27, 2009 12:27 am
- Forum: Fans and Control
- Topic: How to Remove Speed Switch
- Replies: 5
- Views: 2559
Antec had issued a statement earlier year that their Tri-Cool fans had poor patch which would cause them not work perfectly. How old is your antec fan? If itsl ess than a year, contact antec and they'll ship you new one for free. Antec's warranty services are top notch. However wouldn't it be cheape...