I've been using speedfan for a while now and i notice that my fans rpm don't show up when i run speedfan. Everything else works but not the fans.
I notice that the Fan RPM only shows up after i run EVEREST.
Is there anyway to fix this problem?
My specs are below:
Mobo: MSI Neo4 Platinum Nforce 4, the northbridge is using the zalman heatsink
GPU: AMD 64 3200+ winchester core with XP-90AL heatsink
Graphics: ATI X800XL with VF-7000CU heatsink
Case: Lian Li V-1200B
Memory: 2x512mb of Cosair value PC 3200
Hard drive 1: Samsung 80 gig SATA hard drive
Hard drive 2: Maxtor 120 gig IDE hard drive
Sound card: Audigy 2
speedfan doesn't work properly
Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee
-
- Patron of SPCR
- Posts: 2674
- Joined: Sun Jul 04, 2004 6:07 am
- Location: Houten, The Netherlands, Europe
Thanks to ImageShack for Free Image Hosting
- Start SpeedFan and go to the screen above.
- Note the values that are shown after FANx mult and FANx div (were x is a number).
- Close the screen.
- Do what you normally do with Everest that let the RPM's show in SpeedFan.
- Go again to the screen above and look if the values have changed.
- If they have changed, then put a checkmark before remember it.