It is currently Tue Sep 25, 2018 1:15 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Fanless miniature PC
PostPosted: Fri Nov 11, 2016 3:28 pm 
Offline

Joined: Wed Mar 19, 2008 10:14 am
Posts: 55
Location: Vancouver, BC
Attachment:
comp36-m s.jpg

  • Streacome FC8 Evo case
  • Zotac GTX 750 low-profile graphics
  • Celeron 35w TDP w/ M-ITX mobo
  • Heatpipes from Newark
  • 2.5" SSD
  • PicoPSU

Attachment:
comp16-m s.jpg

Hardware is about 2 years old now. It works well enough for my light gaming.

Heat pipes only work decently when they're vertical, so the case has to left on its side.

The case heatsink can't handle all of of the heat that the card generates, I use MSI Afterburner to limit the temperature to 78 degrees C. This results in approximately 20% throttling, i.e., the card reaches ~80% of stock performance.

Attachment:
comp08-m.jpg

Drilled new bolt holes into the case heat sink. The bolt holes are where the heat pipe brackets are attached.

Attachment:
comp27-m.jpg

Hard drive and heat pipes are all mounted with 3/4" wide aluminum bar. A single heatpipe that long might not be able to transfer all of the heat from the graphics card, so I have a 2 heatpipes.

Attachment:
comp35-m.jpg

Case has a hole for a standard AC connector. I cut out a piece of the rear grill and also attached the connector for the higher power 4-pin AC converters.


You do not have the required permissions to view the files attached to this post.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group