My Lian Li 6070...new kit update

ashtray_head · Post by **ashtray_head** » Sun May 09, 2004 8:57 am

ok have a lil' update for you guys

Have installed my Zalman CNPS7000A-Alcu and Sammy SP1614C. I had to mount the sammy in the Lian Li bay as you can see but I had to fit it with rubber grommets to stop the seek vibrations. I had to move my old WD up to a 5" bay. this has stopped all the seek noise

With the addition of the Zalman my temps do not go over 50 load even with all fans low and idles in the very low 40's

I also bought the silver bezel to tidy up the front of the case and modded one of the spare bezels to replace the front of the ZM-MFC1 fan controller

As you can see this has made a big difference to the front of my case.

Any opinions good or bad? I think I'm now happy with this case

Post by **Ralf Hutter** » Sun May 09, 2004 2:02 pm

ashtray_head wrote:I also bought the silver bezel to tidy up the front of the case and modded one of the spare bezels to replace the front of the ZM-MFC1 fan controller

As you can see this has made a big difference to the front of my case.

Any opinions good or bad? I think I'm now happy with this case

Mmm, looks schweet!

bigred · Post by **bigred** » Sun May 09, 2004 2:26 pm

Nice job on the Fan Controller bezel! Looks very nice.

shathal · Post by **shathal** » Sun May 09, 2004 3:08 pm

Very nice looking and slick.

Darn clean cutting work on the Zaalman MFC front-panel replacement

.

ashtray_head · Post by **ashtray_head** » Mon May 10, 2004 8:14 am

Thanks guys... much appreciated

As I said before I think I'm now done with this case.....unless I can think of anything else to put in (or remove)