SPCR

Does anyone know if the Plusview 1000 or Antec 1080 AMG can be modded to fit a 120mm fan in the bottom front of the case under the 3.5" bays? I measured this area to be about 4.5" high, but it is too close to say without actually having a fan. I obviously would have to open the front of the case up a bit for airflow. Does anyone know if it will fit or is anyone who has a 120mm fan and this case willing to check? I don't want to buy a $15 fan and have no where to put it. I already have the Plusview 1000 and do not want to buy a new case.

Thanks,
Brian

Brian, You'll need 4.75" x 4.74" at least to put in a 120 fan and I'd allow a tiny bit extra so you can make sure that the fan, once it's mounted on the isolators, does not touch the case.