Case fan exhaust vent duct concept
Posted: Sat Feb 16, 2013 8:10 pm
Any thoughts on this? Sorry for the horrible drawing. Imagine the outer border is the case body, with an opening at the back/top. I remember reading somewhere that fans should have a certain amount of clearance. Seems like it was about 10 mm or so? The point of this is that it would direct noise out the back, and hide the vents for aesthetics.
I guess I could shorten the length of the duct/chamber so that it ends at the edge of the fan nearest the front.
I guess I could shorten the length of the duct/chamber so that it ends at the edge of the fan nearest the front.