Geforce FX5800 + ZM-HP80A (some pics) *EDITED 29FEB04*

They make noise, too.

Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee

Post Reply
Techno Pride
Posts: 347
Joined: Tue Jun 03, 2003 12:57 am

Geforce FX5800 + ZM-HP80A (some pics) *EDITED 29FEB04*

Post by Techno Pride » Sun Feb 22, 2004 8:52 pm

some early pics...I need to dismantle the whole thing again because one of the parts is defective. Probably xchanging for a new set of heatpipe. Will update with more pics soon.

back side
Image

after i ripped the noisy little bitch off the card...
Image

The Zalman installs fine with the ramsinks intact.

At the moment, I am running the card without tapping power from PSU...the core is running @ 250MHz, memory@500MHz. The card is cooled with a 80mm Panaflo L1A.
Image
Last edited by Techno Pride on Sat Feb 28, 2004 8:22 pm, edited 1 time in total.
Top
Techno Pride
Posts: 347
Joined: Tue Jun 03, 2003 12:57 am

Post by Techno Pride » Sat Feb 28, 2004 8:20 pm

the front Zalman heatplate
Image

enough clearance for stock ramsinks on the front of card
Image

the rear ramsink plate causes the zalman's rear heatsink base to be slightly off balance.
Image

top view
Image

back Zalman heatplate
Image
Top
Techno Pride
Posts: 347
Joined: Tue Jun 03, 2003 12:57 am

Post by Techno Pride » Sun Feb 29, 2004 8:42 pm

FINAL PRODUCT

I secured a 80mm Panaflo L1a to the card using cable ties.

Image

The card installed...

Image

Image

running at 450core/900mem. Card goes up to ard 72C in 3D mode.
Top
Post Reply

Return to “Video Cards & Monitors”