45mm (Square) 64mm (Circular) Contact Water Block Needed...
Posted: Mon Jul 07, 2008 4:57 pm
Trying to cool down the hot side of a TEC module to get the cool side to ice over...
I have come to the realization that my water block MUST have a contact area of about 45mm square or about 60-65 circular diameter to completely cover the TEC module or else the exposed areas will cause the cool side to loose its effectiveness and will NOT produce ice (or just get really cold)... =]
This one is big enough but a little on the expensive side...
OH CANT POST A LINK YET... =P
Its a "D-Tek FuZion CPU Water Block" for around 65 Duckets...!!
Any suggestions for a cheaper model with a large enough contact area... ??
I have come to the realization that my water block MUST have a contact area of about 45mm square or about 60-65 circular diameter to completely cover the TEC module or else the exposed areas will cause the cool side to loose its effectiveness and will NOT produce ice (or just get really cold)... =]
This one is big enough but a little on the expensive side...
OH CANT POST A LINK YET... =P
Its a "D-Tek FuZion CPU Water Block" for around 65 Duckets...!!
Any suggestions for a cheaper model with a large enough contact area... ??