pump preasure and loop advice
Posted: Mon Dec 07, 2009 7:07 am
Hi all!
I'm building WC loop of two blocks CPU and VGA:
CPU (Max TDP 95-110W)
VGA 5770
NO OC
So I was wondering if anyone can give me an advice on some questions...
After I ave read few post from here, I decided which tubing I should use (1/2 ID), if I'm wrong with this choice - please, correct me.
1. Would a single 120 rad be enough (i.e. DD Stealth GTS 120) with Noctua fan @ 900 rpm
2. Would OCZ Hydro 500 pump (500 l/h) (or same from EK or DD)would be enough for such loop as i'm for the most silent/price ratio. Is it ok to slow down it even more to make less noise.
3. Is this loop setup correct Res-->Pump-->CPU-->VGA-->Rad, couse I've read a few posts were some recommends to use rad after pump as it heats up water a little.
THX in advance.
I'm building WC loop of two blocks CPU and VGA:
CPU (Max TDP 95-110W)
VGA 5770
NO OC
So I was wondering if anyone can give me an advice on some questions...
After I ave read few post from here, I decided which tubing I should use (1/2 ID), if I'm wrong with this choice - please, correct me.
1. Would a single 120 rad be enough (i.e. DD Stealth GTS 120) with Noctua fan @ 900 rpm
2. Would OCZ Hydro 500 pump (500 l/h) (or same from EK or DD)would be enough for such loop as i'm for the most silent/price ratio. Is it ok to slow down it even more to make less noise.
3. Is this loop setup correct Res-->Pump-->CPU-->VGA-->Rad, couse I've read a few posts were some recommends to use rad after pump as it heats up water a little.
THX in advance.