I have this little daughter board and there is a chipset which heatsup like good'ol 486DX50.
There is no nativly support for the Heatsink so I have to improvise.
Here are some pics
Pic 1
Pic 2
Pic 3
Pic 4

Mods / Admin: If I have posted this at wrong section please move it where it needs to be
Thank you

Any chance of thumbnailing these pictures? They're rather big on screen and will break formatting for most users.

Is there any reason why you're concerned about this chip heating up? The manufacturer has clearly intended it to run that way as it is just a low power network controller. You also risk damaging things if you were to, say, get some thermal paste bridging the contacts and end up shorting it out. I seriously wouldn't bother.

Have you looked at Enzotech copper heatsinks ? Those little things are pretty good (but a bit expensive)

I am not sure how to use thumbnail on this BBCodes Sorry
I am thinking about these Akust Aluminum Memory Chip Heatsink

That should help.

It gets way too warm' causing lock up on errors on the chip!
I think this is better by the size of the heat sink (2side by side) ]url=http://www.frozencpu.com/products/5557/vid-86/Swiftech_MC21_Aluminum_MOSFET_Heatsinks_-_4_pack.html?tl=g40c16s226]Swiftech MC21 Aluminum MOSFET Heatsinks [/url]