|
As long as you have enough SATA power connectors (or adapters), without a doubt the PSU will be OK.
Most desktop hard drives use less than 10w when running, and about 20w when starting up. With 14 hard drives, you're looking at a worst-case load of about 280w if all the drives are spinning up at the same time. Seeing as even the G-450 can supply approximately 400w on its 12v line (which would be used to drive the motor), you are definitely safe with an 850 power supply.
While there's nothing wrong with getting a very powerful power supply, I would at least think about getting one a little less powerful.
|