Hi
jc-fury, you asked in a PM about installing/enabling the GiveIO.SYS driver. Unfortunately, on 8rdacore's home page it's a bit vague about this. Anyway, here is the info you need that should get you going:
For Windows NT &2000
1. Copy the included GIVEIO.SYS file to your C:\WINNT\system32\drivers directory.
2. Open the Control Panel and select Add/Remove Hardware Wizard.
3. Follow the directions for adding a new device.
4. Select “Select hardware from list” and then choose NEXT.
5. Select “Ports” from the hardware list and then choose NEXT.
6. Select “Have Disk” and browse to the giveio.inf file.
7. Confirm and finish the installation by choosing NEXT and then FINISH.
________________________________________________________
For Windows XP
1. Copy the included GIVEIO.SYS file to your C:\WINNT\system32\drivers directory.
2. Choose “Add Hardware” from the Control Panel
3. Choose NEXT when the Add Hardware Wizard appears.
4. Check “Yes, I have already added the hardware” button; then choose NEXT.
5. Scroll down and select “Add a new hardware device”, then choose NEXT.
6. Select “Install hardware manually from list”, then choose NEXT.
7. Select “Ports” from the hardware list and then choose NEXT.
8. Select “Have Disk” and browse to the giveio.inf file.
9. Choose OK, then NEXT, then NEXT, then CONTINUE ANYWAY when the digital signing warning message appears.
10. Confirm and finish the installation by choosing NEXT and then FINISH
Next time you run 8rdacore it should work, although you may have to do a restart. After this you should be able to configure it on the settings page, but don't go too mad to start off with.
Good luck & let us know how you get on!