It is currently Wed Dec 17, 2014 5:34 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Where to find hardware/parts for a Lian Li PC-Q18
PostPosted: Sat May 04, 2013 8:22 am 
Offline

Joined: Sat May 04, 2013 6:17 am
Posts: 7
Hello all -
Long time lurker/learner/processor finally decides to get on board and participate...
I'm currently building/modding a MI-008 based file server and am looking for a hardware pack from a PC-Q18, specifically the 2.5" drive mount screws/rubber o-rings [but 3.5" screws & o-rings would be good too] so that I can 'bayonet mount' some drives. I can find the 3.5" screws/o-rings on-line - although only in Qty 4 or in a large kit that has little of what I'm looking for - but not the 2.5" variety. I'd like to find at least as many as come in the hardware kit, more would be better.

Speaking of bayonet mount, I'd also like one of the bottom of case trays from a PC-Q18 or some pictures and detailed measurements. I'd prefer the tray however. I though there might be someone here that removed their tray due to installation of a hi-perf graphics card and it's just laying around gathering dust. :P

I've contacted a few vendors that sell Lian Li case parts, but have had no responses.

Thanks!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group