It is currently Mon Dec 16, 2019 2:42 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: How and where to attach tempurature probes
PostPosted: Sat Sep 11, 2004 5:38 am 
Offline

Joined: Thu Jul 01, 2004 4:55 am
Posts: 168
Hi All,
I have an CoolerMaster Aerogate III (same as the CM Cooldrive 6 -harddrive cooler) coming in Monday with an Thermalright XP 120 and Arctic Cooler NV5 following shortly.
My Chaintech VNF3-250 has no fan control and the cpu temps reads close to 80C. I plan on using the Aerogate to monitor temps of the cpu, gpu, power supply, and either chipset or "ambiant" and control the cpu and gpu fan speeds. The Aerogate has no automatic fan control function. I may also control a side fan speed. The two 120mm case fans are (apparently) dead silent at 12v. This may change when I get the BFG 6800GT quieted down.

I would like to finalize the temp sensor (4 flat style) positions on my current set up for comparisons sake, as well having all the wires routed before I install the new heat sinks.

Since I've never done this before any tips, modifications, help of any type would be appreciated. No I won't put a sensor between a chip and heatsink!!! If I can get some good data on these new products I will report to the appropriate forum.

Thanks in advance!!

_________________
The GlassMan
Silicon, at the bleeding edge of technology for 20,000 years


Top
 Profile  
 
 Post subject:
PostPosted: Tue Sep 14, 2004 1:31 pm 
Offline

Joined: Fri Aug 01, 2003 10:45 pm
Posts: 587
Location: North Billerica, MA, USA
For a CPU, the best place IS between the HS and the chip carrier. NOT between the die and the HS, but next to the die in the gap between the carrier and the HS. Otherwise the best bet is to figure out where the airflow hits the various parts you want to monitor, and put the sensors on the side AWAY from the airflow, and in contact with the parts as much as you can.

Gooserider

_________________
Building Dual Athlon MP system, Tyan mobo, U160 drives, Server Cube case, Linux ONLY, lots of other goodies. Will water cool, attempting to make as silent as possible.


Top
 Profile  
 
 Post subject:
PostPosted: Wed Sep 15, 2004 2:08 am 
Offline

Joined: Thu Jul 01, 2004 4:55 am
Posts: 168
Thanks Gooserider, I appreciate the airflow trick, all my research didn't turn that up. I've been playing with the sensors and the are indeed sensitive to air flow. I'm assuming the carrier is the circuit board the a64 is mounted to. Thanks again.

_________________
The GlassMan
Silicon, at the bleeding edge of technology for 20,000 years


Top
 Profile  
 
 Post subject:
PostPosted: Tue Sep 21, 2004 7:15 pm 
Offline

Joined: Fri Aug 01, 2003 10:45 pm
Posts: 587
Location: North Billerica, MA, USA
Quote:
Thanks Gooserider, I appreciate the airflow trick, all my research didn't turn that up. I've been playing with the sensors and the are indeed sensitive to air flow.

You're welcome. The airflow thing is one of those 'obvious' things that nobody thinks to point out, but as you are finding out, it does make a difference.

Quote:
I'm assuming the carrier is the circuit board the a64 is mounted to. Thanks again.

Yes, that's what it is. The kind of thing that's sort of hard to put a name on that differentiates between the die and the rest of the chip surface... Things were so much simpler back in the old days when chips were so cool you didn't have to worry about temps :)

_________________
Building Dual Athlon MP system, Tyan mobo, U160 drives, Server Cube case, Linux ONLY, lots of other goodies. Will water cool, attempting to make as silent as possible.


Top
 Profile  
 
 Post subject:
PostPosted: Wed Sep 22, 2004 12:04 am 
Offline

Joined: Wed Aug 18, 2004 12:06 am
Posts: 60
Location: South Coast, UK
Glassman,

Could you tell me what you think of the Aerogate III now that you've used it for a while? Is it a good fan controller, easy to use, etc? I've been looking around for one for a system I'm planning and the AIII looks pretty decent.

Thanks,
Nik


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group