So I'm using Speedfan 4.18, monitoring three fan speeds....everything's ok.. Then I installed MBM (last version) because I knew my board supported it, and I wanted the additional temp icons in the tray.
Well as soon as I installed MBM, neither prog would read RPMs below 1350....reading drops to zero. I adjusted the Speedfan settings.....the fan devisor setting. Then both progs read RPMs ok.
It's hard to figure how a Speedfan setting would affect the MBM reading...
I'll reiterate what I've already stated here on countless
DO NOT run two monitoring apps at the same time. They will "fight" for the same sensors and at best, give you inaccurate readings, and at worst, make your system unstable. Some folks go so far as to not even install
multiple monitoring apps, I don't go that far but I always check the startup folder (and where ever else) to make sure only one will be running at any given time.