mbm5 cpu and case temp

bendit · Post by **bendit** » Sun Apr 10, 2005 12:17 pm

Hello,

I downloaded and ran this program when I was using an xp-120 and it seemed to work fine. I switched to a AC Freezer 7 and now I can't seem to get the program to display a temp for the CPU or Case where it actually says CPU and Case. It is showing up only as sensor 1 sensor 2 and sensor 3....Is there a way to get it to say CPU and CASE like it did before?

Regards,

Mike

Post by **Rusty075** » Sun Apr 10, 2005 1:00 pm

Run the configuration wizard. (accessible via MBM's Start menu entry)

bendit · Post by **bendit** » Sun Apr 10, 2005 1:05 pm

Thanks Rusty.