Good morning to everyone.
Thanks to SPCR for Zalman Z9's review, I liked it very much and decided to try this case.
I currently have it @ home, going to build a little new system this incoming weekend.
Some things to ask / discuss with you:
a) I will put a low heat system inside my Zalman Z9 (Intel I3 + an SSd + 2,5" HDD + CPU Cooler Arctic Freezer Extreme // no VGA at all, using the integrated GPU). May be I will take off the CPU cooler fan (I would like to be fanless as a CPU cooler).
I would like to try a "positive pressure" situation, trying to avoid dust in my system, going to use the top fan x 2 (putting the side fan on the top), rear fan, front fan as intake fans; all of those 4 fans will be reduced to minimum speed; little remaining heat will go away through the side panel mesh. What do you think about this?
b) Will have to decide if my PSU (Be Quiet E9 400) will be face up or face down. I'd like face down position, but I'm a little worried about dust. Anyone will help me to decide? May be the PSU it's too far from the bottom to suck dust?
That horrible molex powdered rear fan (the white one). I will connect all the other fans to fan controller provided with the case (with y-cables), but that fan, I only have the option to power it via a molex connector, so ... How can I control that??? (obviously, I could swap that fan, but I'd like to use all the provided fans...). How could I make that fan slow, being forced to connect that to a molex, directly to the PSU??
Thanks to you all.
Excuse me for my bad English.