Just a few images for those interested in this combination :
As you can see, everything fits just fine, except few small issues :
1) the 9.2cm fan had to be pushed back to heatpipes as much as possible, because otherwise it would block the first RAM slot.
2) the 9.2cm fan holder on the VRM module side had to put there before the fan was pushed in, and then i had to put the bottom part through fan holes with the fan and cooler already mounted, which was "fun".
The only problem i found later was that while installing the board in PC-Q08, the heatpipe closest to the VRM module was hitting the mounting bracket of hard drive holders inside the case, but it was possible to mount the board, it was just a little bit harder to do.
The cooler doesn't block anything, it is well clear of PCI-E socket, i was even able to use the top white SATA3 connector without a issue.
Initial testing shows ~30C idle and ~55C load temperatures at stock clocks (1.6 idle - 3.6GHz OCCT).