my quiet antec 3000b (not 56k friendly)
Posted: Wed Mar 01, 2006 3:24 pm
Here’s a couple shots of my main pc, most of the hardware is old news now. But I just gave it an upgrade just recently, in the form of a sythe ninja, so i desided to take a few pictures and share.
the heart of my system:
Intel d75pbz refference board
Intel P4 3.2ghz Extreme Edition (800fsb 512kb l2 2meg l3 cache)
2x512mb (1gig) DDR400-PC3200 generic MT chips 3-3-3-8 timing
ATI X800XT AIW
2x Seagate 300gig SATA 7200.8 series harddrives
Soundblaster Audigy 2ZS
Sony floppy
Pioneer a08 dvd-rw w/gradious 1.20 RPC-1 Rip-lock free firmware
Windows XP Pro OEM SP2
cooling and power specs:
Antec 3000b case
Seasonic Super Tornado 400watt power supply w/Yate-Loon d12sl-12 fan swap
2 Yate-Loon d12sl-12 fans in front and rear (motherboard controlled) idle around 800-850rpm
Scythe Ninja heatsink
Zalman vf-700cu w/Nexus 80mm fan swap
Artic Silver 5 on GPU and CPU
suspended harddrive cage
multi-layer acoustical foam dampening
Vantec silicone power supply gasket (which i doubt did anything)
case fan screw holes tapped out to 1/4" IIRC and installed rubber grommets from sears hardware
custom cardboard air tunnel for Scythe Ninja (made one hell of a difference in system temps)
front honeycomb fan grill cut out
bottom of front face cover sealed, only filtered air enters this case
accrilic cutout covering TEC-II hole, on side panel
air conditioning filter cut to fit over lower side panel vent
all unused case holes sealed with clear tape, to keep out the dust
the heart of my system:
Intel d75pbz refference board
Intel P4 3.2ghz Extreme Edition (800fsb 512kb l2 2meg l3 cache)
2x512mb (1gig) DDR400-PC3200 generic MT chips 3-3-3-8 timing
ATI X800XT AIW
2x Seagate 300gig SATA 7200.8 series harddrives
Soundblaster Audigy 2ZS
Sony floppy
Pioneer a08 dvd-rw w/gradious 1.20 RPC-1 Rip-lock free firmware
Windows XP Pro OEM SP2
cooling and power specs:
Antec 3000b case
Seasonic Super Tornado 400watt power supply w/Yate-Loon d12sl-12 fan swap
2 Yate-Loon d12sl-12 fans in front and rear (motherboard controlled) idle around 800-850rpm
Scythe Ninja heatsink
Zalman vf-700cu w/Nexus 80mm fan swap
Artic Silver 5 on GPU and CPU
suspended harddrive cage
multi-layer acoustical foam dampening
Vantec silicone power supply gasket (which i doubt did anything)
case fan screw holes tapped out to 1/4" IIRC and installed rubber grommets from sears hardware
custom cardboard air tunnel for Scythe Ninja (made one hell of a difference in system temps)
front honeycomb fan grill cut out
bottom of front face cover sealed, only filtered air enters this case
accrilic cutout covering TEC-II hole, on side panel
air conditioning filter cut to fit over lower side panel vent
all unused case holes sealed with clear tape, to keep out the dust