Enclosures and acoustic damping to help quiet them.
Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Devonavar
-
sdan
- Posts: 9
- Joined: Fri Jul 30, 2004 5:45 pm
Post
by sdan » Wed Aug 11, 2004 11:39 am
It feels like it is clamping down too hard. This is a new case, and it doesn't appear to be bent. Has anyone else had this problem or know of a way to fix it?
-
VultureJ
- Posts: 18
- Joined: Sun Jul 18, 2004 7:48 pm
- Location: Fremont, CA, USA
Post
by VultureJ » Wed Aug 11, 2004 2:59 pm
I don't have the BQE, but I do have the 3700AMB, and I've noticed that with my case as well.
It seems that the lower latch plastic sticks, and doesn't move smoothly. As for how to fix it, well, I haven't really looked into that.
-- Joe
-
sdan
- Posts: 9
- Joined: Fri Jul 30, 2004 5:45 pm
Post
by sdan » Thu Aug 12, 2004 7:46 pm
I sent an email to Antec asking for advise also, and perhaps a new side panel.... I'll post what they say when/if i get a reply.
-
mg1394
- Posts: 167
- Joined: Sun Aug 11, 2002 3:26 pm
- Location: Silicon Valley
Post
by mg1394 » Thu Aug 12, 2004 8:46 pm
Check that the side panel is sliding forward enough. The problem you are having is usually not the side panel, but the front of the case not letting it slide forward enough to seat, and the locks at the back are not contacting the case in the proper points.
-
acaurora
- *Lifetime Patron*
- Posts: 1464
- Joined: Mon Dec 29, 2003 2:51 am
- Location: Elk Grove, CA
-
Contact:
Post
by acaurora » Thu Aug 12, 2004 9:45 pm
I have a BQE, and to me it is somewhat similar: Both latches close, but the top latch seems to be rougher while closing the latch. The lower latch closes smoothly, whereas the top one has some resistance against it. But hey, it closes, and nothing looks worn/broken, so it's all good
-
RaNDoMMAI
- Friend of SPCR
- Posts: 337
- Joined: Thu Jan 15, 2004 8:12 am
Post
by RaNDoMMAI » Fri Aug 13, 2004 4:34 am
my latches are weird too now, only one will close and the other doesnt. ususally the bottom.
I dont really care anymore as i been opening and closing my case so much trying new things.
~RaNDoM
-
nickdeck
- Posts: 50
- Joined: Thu Mar 25, 2004 1:24 pm
-
Contact:
Post
by nickdeck » Fri Aug 13, 2004 5:10 am
Haven't seen that problem on my 3700BQE, and I've been in and out of there dozens of times.
Nick
-
sdan
- Posts: 9
- Joined: Fri Jul 30, 2004 5:45 pm
Post
by sdan » Wed Aug 18, 2004 9:52 am
Antec never responded, so last night, I decided to try and fix it myself. I studied the latches for a while and it became obvious that the bottom latch was just pulling too hard. I bent the piece of metal the latch grips out about 2mm so it wouldn't have to pull so hard and now it stays closed like it's supposed to. no rattling either.