The picture in the manual is very small and difficult to see...
Do you twist the rubber mounting cables completely around, for a tighter fit on the drive? Or do you insert the drive without twisting the cables completely around?
Quick question on P150 drive installation
Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Devonavar
-
- Posts: 137
- Joined: Sat Jul 24, 2004 5:03 am
For a loose fit a half twist will do - having no twist at all will result in the drive not being held in place and falling out when moving the machine.
For a firm fit a full twist is better - have top back on top, bottom back on bottom.
All the above applies to 3.5" drives. For 2.5" drives multiple twists are probably required.
For a firm fit a full twist is better - have top back on top, bottom back on bottom.
All the above applies to 3.5" drives. For 2.5" drives multiple twists are probably required.