NSK 3480 case - Do you use the CPU side panel duct?
Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Devonavar
NSK 3480 case - Do you use the CPU side panel duct?
I just purchased the Antec NSK 3480 case and was curious if most people use the supplied CPU side panel duct.
If you could give the reason why that would also be helpful.
Picture of the duct from the review here:
http://www.silentpcreview.com/files/ima ... alduct.jpg
Thanks!!
If you could give the reason why that would also be helpful.
Picture of the duct from the review here:
http://www.silentpcreview.com/files/ima ... alduct.jpg
Thanks!!
Same here.didi wrote:Don't use it.
Actually I switched the side panels. Less inside noise escaping. Plus left side faces me, so no ugly grate.
If anyone is interested, here's my build with the NSK3480 and switched panels: viewtopic.php?p=438076#438076
Just for more information, I am going to start with the stock cooler but I want any replacement CPU cooler to be a blow down variation as the motherboard I purchased has (some) reports of high chip-set temperatures if you do not have any air blowing over it.JamieG wrote:The thermal duct is really only of any possible use if you are using the stock CPU cooler or another blow down after market cooler.
-
- Posts: 71
- Joined: Mon Jan 19, 2009 1:15 pm
- Location: New Zealand
So far no one uses the duct!?! Begs the questions on why it is there? Sounds like people here don't like the sound escaping "feature", correct? Do most people uses a large / tower heat-sink and so it doesn't work anyways?
Confuses me on why they would add a feature that has no benefit. Just to comply with the Intel standard? If it has no benefit why does Intel want this venting?
Bit confused here
Confuses me on why they would add a feature that has no benefit. Just to comply with the Intel standard? If it has no benefit why does Intel want this venting?
Bit confused here
No, I remove the duct and seal the holes in the side pannel
Is how I voted, cause that's how all the big boys do it my mom told me.
But seriously, I had CPU duct holes and more regular air flow holes underneath. I covered them both with some dark gray anti-static film and then put thermaltake sound dempening foam over them. (applied a whole sheet to that panel.)
Yeahhhhh boyeeeee... highest my cpu has ever been recorded so far was playing games like Call of Duty Modern Warfare 2 at like 51C
120mm fan on the front 120mm fan on the back and im stacked like a G!
Is how I voted, cause that's how all the big boys do it my mom told me.
But seriously, I had CPU duct holes and more regular air flow holes underneath. I covered them both with some dark gray anti-static film and then put thermaltake sound dempening foam over them. (applied a whole sheet to that panel.)
Yeahhhhh boyeeeee... highest my cpu has ever been recorded so far was playing games like Call of Duty Modern Warfare 2 at like 51C
120mm fan on the front 120mm fan on the back and im stacked like a G!
The side panel duct is not in the right place for all motherboards. In particular, all of the new socket 1156 mobos have the cpu socket further away and towards the bottom of the case than the location of the side panel duct, even if you are using a stock or blow down cooler. It sure does not help with a tower cooler. I suspect this feature generally will go away as the realization that Intel is happy to move the CPU socket around sinks in. If it were up to me, I would put a vent in the side panel somewhere near the rear bottom of the case to let air in over the hard drive and in front of the video card.