Is it safe to suspend hard drives?

New to PC silencing? Read & post your questions here. Dedicated to rosy_toes.

Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee

Post Reply
derekchinese
Posts: 255
Joined: Fri Mar 02, 2007 6:57 pm
Location: Nowhere.

Is it safe to suspend hard drives?

Post by derekchinese » Fri Mar 02, 2007 7:08 pm

First of all HI! I am new to posting on SPCR, but I have been reading SPCR articles and lurking the SPCR forums for a while. My question is: does suspending shorten the life of the hard drive? I know from SPCR's article that it causes the hard drive to get alittle hotter, but does the fact that the hard drive isn't secured cause the hard drive to die quicker? I have been told that it is not a good idea for the hard drives to be able to move at all--that it was not good for the hard drives life. But I know that alot of silent pc enthusiasts seem to use suspended hard drives without any problem.

Thanks in advance! :)

MikeC
Site Admin
Posts: 12283
Joined: Sun Aug 11, 2002 3:26 pm
Location: Vancouver, BC, Canada
Contact:

Post by MikeC » Fri Mar 02, 2007 9:55 pm

Here's a white paper from the world's biggest HDD maker -- Seagate -- on HDD Acoustics. (Note: The Seagate's site has recently been changed; this very informative paper is no longer publicly linked there, so save it if you want to go back to it.)
Seagate wrote:Seagate has made significant progress in the area of isolator design and development. Isolators are mounting mechanisms made of a softer material than metal; they are used to separate, or isolate, the drive from the chassis, minimizing the transmission of structure-borne vibration and noise.

At one time, years ago, isolators were thought to be impractical for disc drive mounting; the frequent long seeks could induce excessive drive motion through isolator "wind up" and "release," which caused settling problems during seeks, which could in turn reduce drive performance and/or data integrity. Current drive designs, combined with Seagate's research and development of new isolator materials and designs, have largely eliminated these issues. In typical PC applications, over 90 percent of all seeks occur within only 30 tracks, which is less than 1/4 of 1 percent of the drive's tracks, inducing very little motion and wind up. The materials Seagate recommends for isolators are highly damped rubber compounds, which minimize the possibilities for wind up, amplification and other unstable conditions.

Our testing indicates that WinBench scores (industry-standard drive benchmarks) are not affected by mounting drives using isolators. Further testing beyond the bounds of common disc drive functions did reveal that when performing high numbers of long seeks (long seeks are becoming more rare as track densities increase), write performance could be somewhat reduced, while read performance remains unchanged. Again, most drives perform many more reads than writes, so that overall performance, even in these extreme circumstances, is not perceivably affected.
I had two Seagate Barracuda IV HDDs suspended in elastic for over four years w/o any problems from either. The 40GB discs are too small for my needs now; they are floating in the lab, still functioning fine.
Mike Chin, SPCR Editor/Publisher
Support SPCR by buying your gear through this link: Amazon

derekchinese
Posts: 255
Joined: Fri Mar 02, 2007 6:57 pm
Location: Nowhere.

Post by derekchinese » Fri Mar 02, 2007 10:52 pm

alright, thanks for the informative post MikeC!

Gxcad
Patron of SPCR
Posts: 429
Joined: Sun Aug 11, 2002 3:26 pm
Location: San Francisco, CA
Contact:

Post by Gxcad » Sat Mar 03, 2007 1:19 am

Wow, you learn something new everyday. Thanks Mike, that was an interesting read.

flarkit
Posts: 45
Joined: Fri May 20, 2005 9:21 pm
Location: ZA

Post by flarkit » Wed Mar 07, 2007 4:15 am

Dang! There goes my theory about the risks of suspending.

I've had 2 Seagate SATA300 7200.9's firmly suspended with some climbing rope for the past 6 months, 1cm from a 120mm intake fan. In the past month, my data disk just stopped working and this week my OS/Apps disk started showing some strange behaviour as well.

I hope this isn't perhaps a sign of a failing PSU (450W Antec SP-II, less than 1 year old)

:?
[b]PC Specs:[/b]
MSI 890FXA-GD70, PhenomII 965 rev C, Zalman CNPS10X Quiet, 2x2Gb OCZ DDR3-1600, MSI N460GTX Cyclone, 3x1Tb 7200.12, LG DVDRW, CM 690-II Plus, TY-140, 2x 120mm CM fans, CM GX550w, SB X-Fi

DanW
Posts: 190
Joined: Fri May 19, 2006 3:20 am
Location: UK

Post by DanW » Wed Mar 07, 2007 5:34 am

thanks Mike, useful info there. Which I sort of already knew, but having it confirmed by Seagate in writing makes me slightly more confident in suspending my drives.


Thanks,
Dan
[size=75]Main Rig - mobo: AV8-X cpu:4600+ psu:Phantom hsf:fanless scythe ninja case:P180 gpu: 7800gs (7900 chip) (almost silent except for the HDD)
Server Rig - cpu:2000+ psu BeQuiet ATX1.3 450w hsf: AeroCool HT-101 gpu:GeForxe MX440 (now near silent). Too many hard-drives that make it loud, and an immense amount of ducting that brought temperatures down by 20 degrees.

[/size]

Post Reply