Advice on single fan system w. Thermaltake Big Water

The alternative to direct air cooling

Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee

Post Reply
msmrodan
Posts: 31
Joined: Sun Apr 20, 2003 1:41 pm
Location: Israel
Contact:

Advice on single fan system w. Thermaltake Big Water

Post by msmrodan » Sun Jan 23, 2005 12:31 am

Hi fellow SPCR'ers,

I currently own an ABIT NF7-S with XP1700 Palomino, stuck in an old AT case with a Seagate 160GB 7200.7, Zalman Passive NB heatsink.

My plan is to buy an Antec Super Lanboy case, Nexus 4090 PSU, Thermaltake Big Water and XP2500 Mobile processor.

I want to then remove the 120mm fan from the rad on the big water and screw it in directly below the nexus PSU fan inlet inside the case, in the hope that enough airflow will be generated to keep all temps at a reasonable rate.

From looking at the spec sheets for the lanboy and big water, I think I could squeeze the rad in there. I don't really want a bigger case and the lanboy fits my needs perfectly.

Wanted to ask you whether you have experience with the pump on this kit, how noisy is it? Also any other thoughts would be appreciated.
System 1: Antec Lanboy - XP2500M .Rebuilt Front Bezel w. Plexi & Modders Mesh, Crystalfontz LCD w. Keypad - UV coated S.Tornado A3 - front grille cut out - Motorized sliding door - Hand etched & lighted DVD stealthing. 2 slow 120mm fans. http://i5.photobucket.com/albums/y198/msmrodan/CIMG0268.jpg
System 2: AMD64 3200-Asus K8V Deluxe-1GBCorsair-Zalman Reserator

Post Reply