Possible water cooling setup. Will a ZM-GWB1 fit on a 6800?

DryFire · Post by **DryFire** » Sat Dec 25, 2004 7:58 am

Well I'm looking to water cool my computer.

Does anyone know wether the zalman vga blcok will fit on my 6800? It seems like it will but I don't know for sure. Does anyone have one mounted on their's?

So far I'm planning:
An MCW-6002-64
Zalman ZM-GWB-1
7/16" ID tubing and clamps
Fedco 2-342 heater core w/ 2 120mm fans.
Maxijet-900 water pump

Loks like it's going to be about $100.

Any comments/suggestions?

arsenal · Post by **arsenal** » Wed Dec 29, 2004 4:08 pm

I emailed Zalman wondering the same thing and they informed me that it will not fit. They are currently working on a block for that series of cards to be paired with the reserator.

nici · Post by **nici** » Wed Dec 29, 2004 4:15 pm

There was info about this in some thread here.. Apparently the problem was that the supplied screws were too thick and didnt go thru the holes on the pcb.

DryFire · Post by **DryFire** » Wed Dec 29, 2004 8:23 pm

guess I'll try to find skinnier screws.