Reserator & Dangerden Chipset Block

gremboid · Post by **gremboid** » Tue Dec 20, 2005 4:42 pm

Hi,

I'm going to use the Zalman Reserator +1 to cool my system. When using 2 graphics cards, it has been reported that Zalmans water block doesnt fit properly.

Therefore I have found an alternative block; one made by DangerDen especially for the motherboard I have (Asus A8N-SLI)

Heres a link: http://store.over-clock.com/Chipset_Blocks.html

Now, will the reserators tubing be compaitable with this block right out of the box? The block supports 1/2" and 3/8" barbs, and you can select the ones you want when purchasing.

Thanks

nici · Post by **nici** » Tue Dec 20, 2005 8:05 pm

Should fit nicely as long as the outer diameter of the block fitting is larger than the inner diameter of the tubing(8mm), the silicone tubing is pretty flexible

olyar15 · Post by **olyar15** » Thu Dec 22, 2005 11:56 pm

That is what I am using in my system. The 3/8" barb works fine.