Mating Dell DA-2 and Pico power supplies
Posted: Fri Sep 04, 2009 7:53 am
I have acquired a Dell DA-2 AC-DC powerbrick and PW-200-V pico power supply, but I am flummoxed by their connectors.
Is there a pre-made Molex plug that fits into DA-2's receptacle connector?If not, can I replace the existing DA-2 connector with some other receptacle? For instance, there are 8-pin ATX extension cables such as this one. One should be able to salvage the connectors at the two ends of the cables to make a mating combination.
Thanks for your help.
Uday
Edit: In the thread Antec NSK1300 with PW-200-V, Eitheta speculated that the Molex plug 39-01-2081 (8-position panel-mount connector) should be able to fit the DA-2 receptacle. However, the data sheet for this connector shows that the pin 1 housing is square, whereas the DA-2's pin 1 is round. So it doesn't seem to me that this plug would fit.
Is there a pre-made Molex plug that fits into DA-2's receptacle connector?If not, can I replace the existing DA-2 connector with some other receptacle? For instance, there are 8-pin ATX extension cables such as this one. One should be able to salvage the connectors at the two ends of the cables to make a mating combination.
Thanks for your help.
Uday
Edit: In the thread Antec NSK1300 with PW-200-V, Eitheta speculated that the Molex plug 39-01-2081 (8-position panel-mount connector) should be able to fit the DA-2 receptacle. However, the data sheet for this connector shows that the pin 1 housing is square, whereas the DA-2's pin 1 is round. So it doesn't seem to me that this plug would fit.