SpinPoint EcoGreen F4EG 2TB HD204UI/Z4

Silencing hard drives, optical drives and other storage devices

Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee

Vetotat
Posts: 39
Joined: Mon Jun 08, 2009 7:58 am
Location: Sweden

Re: SpinPoint EcoGreen F4EG 2TB HD204UI/Z4

Post by Vetotat » Fri Aug 12, 2011 8:22 am

Abula wrote:Did you updated the firmware of the F4EG?
No, I've heard it's not necessary for drives manufactured after 2010.12 or 2011.01 or something. Mine is manufactured 2011.04. However I'm unsure about what firmware the drive currently has now; some programs (like CrystalDiskMark) says 1AQ10001 (which is the buggy FW, right?) while other reports 1AQ10010 instead.

But, it seems like the problem isn't acute anymore. I rebooted the computer and SMART now says, under "spin up time", that there have been a problem earlier and that the drive has been operated beyond its design parameters. Spin up time is now at 10,3 insted of 24,2 seconds and is labled as "normal".

But can I trust this drive? Should I worry for a premature failure, or crash?

Vetotat
Posts: 39
Joined: Mon Jun 08, 2009 7:58 am
Location: Sweden

Re: SpinPoint EcoGreen F4EG 2TB HD204UI/Z4

Post by Vetotat » Mon Aug 15, 2011 8:14 am

Vetotat wrote:But can I trust this drive?
...I guess no. I'm now unable too reboot while this drive is connected. A cold boot is fine, but since I'm dual booting I reboot quite often. The computer stops at "Detecting SATA port 2" during POST and I can't even access BIOS or anything. My F4EG is connected to SATA port 2...

Post Reply