E8400 w/ Passive mini ninja = 75c @ Full Load.....too high?
Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee
E8400 w/ Passive mini ninja = 75c @ Full Load.....too high?
I'm running a 120mm exhaust fan in my P180 (with a 120mm intake fan in the upper HDD cage) with a passive Scythe Mini Ninja and I'm getting low 40's on idle and 75C @ full load using prime95 (large). Is this too high? I know I will rarely touch the full load temps, but I'm still a tad reluctant to leave this passive setup. Adding the stock 80mm fan lowers the temp to 54C @ full load.
75C with that configuration seems a bit high. gundam83, do you overclock the CPU? If you run it at stock 3.0GHz you could probably lower the Vcore to ~1.1v and get the temps down a bit. You could also try moving the intake fan to the top of the P180 and see if a negative pressure setup (both fans sucking air out of the case) would give any more airflow through the Minja.
Re: E8400 w/ Passive mini ninja = 75c @ Full Load.....too hi
If it's possible, I'd highly recommend doing a little undervolting. I suspect you could get load temps down to around 65C with some good undervolting. Otherwise is there any chance of having a case fan or something else that can help add more airflow near the heatsink?gundam83 wrote:I'm running a 120mm exhaust fan in my P180 (with a 120mm intake fan in the upper HDD cage) with a passive Scythe Mini Ninja and I'm getting low 40's on idle and 75C @ full load using prime95 (large). Is this too high? I know I will rarely touch the full load temps, but I'm still a tad reluctant to leave this passive setup. Adding the stock 80mm fan lowers the temp to 54C @ full load.