"fake" rpm sense

Control: management of fans, temp/rpm monitoring via soft/hardware

Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee

Post Reply
signal64
Posts: 61
Joined: Sun Apr 09, 2006 4:11 am

"fake" rpm sense

Post by signal64 » Sun Dec 17, 2006 5:01 pm

I don't think there is a magic answer to this one but thought I'd ask anyway.

I have a non-PC device that has a fairly noisy Nidec TA300DC 80mm fan.
12v 3pin lead, 35cfm @ 31.7 dBA (4.5 Bels) and looking at the specs runs about 2600 to 2800 RPM. The header on the fan isn't your standard PC type either (but can take care of that).

The problem is if I replace the fan with one that still provides enough air flow but doesn't run at the same RPM the device will consider it a failed fan. In that condition the device won't start.

Like I said, isn't a PC where I can bypass the sense/alarm in setup/bios.
It doesn't have a PC OS (not even an x86 based) and isn't modifiable.

I take it there's no way to fake this out externaly and I need to get a fan that runs at that RPM that is hopefully quieter?

Thanks

BTW - Tried a Panaflow @ 2450 rpm which didn't work.
Last edited by signal64 on Sun Dec 17, 2006 5:53 pm, edited 4 times in total.

Chris Chan
Posts: 436
Joined: Fri Feb 17, 2006 8:15 pm
Location: Michigan

Post by Chris Chan » Sun Dec 17, 2006 5:31 pm

What exactly is the device?
WIP Desktop: DFI R100 industrial PC case, DH61AG, i3-2100, 8GB DDR3, 500GB 2.5" HDD, Linux Mint 12
Laptop: HP tc4400, Core 2 Duo T7200, 3.5GB DDR2, 160GB Scorpio Blue, Ubuntu 11.04

Rusty075
SPCR Reviewer
Posts: 4000
Joined: Sun Aug 11, 2002 3:26 pm
Location: Phoenix, AZ
Contact:

Post by Rusty075 » Sun Dec 17, 2006 6:25 pm

There's some info here: How to make RPM Signal for 2-Wires Fan, but its not exactly a plug-and-play type solution. There's a link to a good schematic here: Adding RPM Sensor to your Fan, but you'll have to be comfortable with a soldering iron.
[size=75][b]Senior Contributing Writer, SPCR[/b][/size]

Post Reply