Replacing stock fan on an old Phenom 965

Control: management of fans, temp/rpm monitoring via soft/hardware

Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee

Post Reply
Mactwenty9
Posts: 2
Joined: Tue Dec 11, 2018 1:20 pm

Replacing stock fan on an old Phenom 965

Post by Mactwenty9 » Tue Dec 11, 2018 1:45 pm

I want to replace the stock fan on an old Phenom II X4 965 w/a Coolink-SWiF2-800-80mm and was hoping someone knowledgeable could answer a couple of questions.

I've read the stock fan is 65mm or 70mm or 80mm depending on search results. Not sure but I believe that's the size for the fan. I believe the Coolink fan will move enough air, CFM wise, for normal speed or perhaps a mild OC. Think I can somehow remove the stock fan, and one way or another connect the Coolink fan to the plastic above the block. If worse comes to worse I'll try gorilla glue or ties.

Anyone ever removed that fan? Can I connect another fan using screws? Anyone know the true size of the stock fan? I guess as long as I can connect a new fan it doesn't matter.


Thanks,

Mac

Arbutus
Posts: 234
Joined: Wed Jun 02, 2010 9:15 pm
Location: Calgary, Alberta, Canada

Re: Replacing stock fan on an old Phenom 965

Post by Arbutus » Wed May 15, 2019 4:11 pm

You are on the right track with your replacement fan choice as the most important part is the fan thickness is 25 mm. There are different editions of the cooler. You'll have to get out the ruler.
-My Main System-
Antec Solution SLK1600 Case, Corsair CX450M PS, i7-3770, ASUS P8Z77-V_LK, Kingston HyperX DDR3-1600 CL9 with XMP, Cooler Master Hyper 212, 1 PWM fan on duct to the rear of the chassis connected to CPU header.

Some things have turned around in our modern society. Long ago when
men would scream and flog the ground with sticks, it was called witchcraft.
Today, it's called golf.

Post Reply