aNTEC P182 + H20-220 APEX ULTRA

The alternative to direct air cooling

Moderators: NeilBlanchard, Ralf Hutter, sthayashi, Lawrence Lee

Post Reply
fotis1972
Posts: 6
Joined: Mon Mar 19, 2007 9:28 am

aNTEC P182 + H20-220 APEX ULTRA

Post by fotis1972 » Thu Jun 28, 2007 3:21 am

I would like to ask something: in p182 the holes is at the bottom side of the case, if i put the radiator upside down would be a problem?? otherwise i must do a long loop to pass through the tubes inside the case??
or any suggestion how i have to put the tubes??
i don't want to make new holes in the back of the case

thanks a lot
Fotis
[/img]

YugenM
Posts: 40
Joined: Wed Feb 14, 2007 9:55 pm
Location: Vancouver, BC, Canada

Post by YugenM » Thu Jun 28, 2007 1:12 pm

Upside down wouldn't be a problem, but let all the air bubbles escape from the radiator during the fill session first before bolting the radiator onto the case in that position.

HammerSandwich
*Lifetime Patron*
Posts: 1288
Joined: Sat Oct 25, 2003 3:21 pm
Location: 15143, USA
Contact:

Post by HammerSandwich » Fri Jun 29, 2007 8:47 am

Or drill a bleed hole in the upper end tank. Plug it with a brass screw and rubber washer, and you'll be good.

zoob
*Lifetime Patron*
Posts: 380
Joined: Tue Apr 13, 2004 7:12 pm
Location: Toronto, ON
Contact:

Post by zoob » Thu Jul 12, 2007 2:01 pm

Why don't Antec and other case manufacturers put stock holes above the 120mm exhaust? Do they think more people would be using external kits like a reserator instead of using a radbox? :|

Post Reply